2019-09-30 FOCALSPEC User quide LCI1220-1620 v1.0
11/31
FocalSpec Oy • Elektroniikkatie 13, FI
-
90590 Oulu • www.focalspec.com
have a lock. Having the lock readily in the open position enables quick and easy
attaching of the SFP+ module.
4.
Carefully insert the cable connector to SFP+ module. Push the connector gently until
it locks in place (step 2). Usually there is an audible “click” when the connector locks
in place. Make sure the lock handle has remained in the open position.
5.
Verify that connector is locked to the SFP+ module by pulling very gently on the
cable: it must not be loose (step 3). If it is loose and detaches from the SFP+ module,
repeat by pushing the connector to the SFP+ module until it locks into place.
6.
Insert SFP+ module to the SFP+ card at PC (step 4). Make sure the SFP+ module is
positioned in the correct way.
◦
CORRECT: There should be a slight resistance when pushing the SFP+ module
the correct way, as the connector in the SFP+ module slides into the connector at
SFP+ slot side. The SFP+ module should not come out very easily.
◦
INCORRECT: If the SFP+ module is inserted in incorrect way, there is no
resistance. The SFP+ module slides out very easily.
7.
Insert the quick connector of the optical cable to the sensor.
7.3
Detaching SFP+ Module from Optical Cable
Steps to detach SFP+ module from optical cable:
1.
Press the lock tab down in optical cable connector (step 1).
2.
Pull the cable out of SFP+ module (step 2).
3.
Place protective caps on the optical cable connector and SFP+ module.