Shen Zhen FEI NI RUI SI TECHNOLOGYCO.,LTD
7
5.1 Firmware upgrade
Warning: Please disconnect any load when connecting to PC for software
upgrade!After opening the PC software to connect the device,After selecting the
correct latest device firmware file and data packet length ( Free Choice),Just
proceed with the firmware upgrade operation. Do not power off the device during
the upgrade process.It will cause the upgrade to fail and cause the device to
crash.
If the upgrade fails accidentally, please disconnect the power and press and hold
the ">" button to power on the device.
Try to re- enter the upgrade mode and turn on the upper computer again to
upgrade the firmware.After the firmware upgrade is successful, the device will
automatically run the latest firmware and the PC software will restart.
5.2 Control operation
First, you must open the correct serial port number before the connect device
button will take effect.When operating the host computer, all control input boxes
cannot be empty,And only numbers and decimal points can be entered ( the
decimal point can only be entered in a specific position to take effect,For example,
voltage 10 . 00 , current 3 . 000 , power 360 . 0 ),The setting will not take effect
until the cursor leaves the input box.
The waveform can be observed by the waveform status light,to determine
whether the waveform status is acquired in real time( Green represents acquiring
data waveform, red represents pause to acquire data waveform), The “ start/
pause” next to the waveform can control the waveform status light,The waveform
can also be zoomed in
by
selecting the designated area with the left mouse
