background image

 

 

Page: 

3

 

Revison: 7

 

CAUTIONS:

 

 

Refer  to  battery  manufacturer’s  specific  recommended  values  for  battery  type  and  charging  rate 

setting.  

 

Do not charge to an improper type of battery.  EG: do not charge AGM battery with Calcium battery 

setting 

 

If longer output charging cord is required; make sure the diameter is adequate for the current in given 
cable length. 

 

Someone should be within range of your voice or close enough to come to your aid when you work 

near a lead-acid battery. 

 

Wear protective goggles and turn your face away when connecting or disconnecting battery. 

 

If  battery  acid  contacts  skin  or  clothing,  wash  immediately  with  soap  and  water.  If  acid  enters  eye, 

immediately 

flush  eye  with  running  cold  water  for  at  least  10  minutes  and  get  medical  attention 

immediately. 

 

To reduce risk; avoid dropping a metal tool onto the battery.  

 

Do not set battery on top of charger. 

 

Make sure charger is as far away from battery as output cables permit. 

 

This appliance is not intended for use by persons (including children) with reduced physical, sensory or 

mental capabilities, or lack of experience and knowledge, unless they have been given supervision or 
instruction concerning use of the appliance by a person responsible for their safety. 

 

Children should be supervised to ensure they do not play with this appliance.

 

 

PREPARING TO CHARGE:

 

a) If necessary to remove battery from vehicle to charge, always remove grounded terminal from battery first. 

Make sure all accessories in the vehicle are off, so as not to cause an arc. Be sure the area around battery is 
well  ventilated  while  battery  is  being  charged.  Gas  can  be  forcefully  blown  away  by  using  a  piece  of 
cardboard or other non-metallic material as a fan. 

b) Clean battery terminals. Be careful to keep corrosion from coming into contact with eyes. Add distilled water 

in each cell until battery acid reaches level specified by battery manufacturer. This helps purge excessive gas 
from cells. Do not overfill. For a battery without caps, carefully follow manufacturer's recharging instructions. 

c)  Study  all  battery  manufacturers’  specific  precautions  such  as  removing  or  not  removing  cell  caps  while 

charging and recommended rates of charge. 

d) Check the battery voltage and make sure it matches the output rating of battery charger.

 

e) Carefully read and understand the battery type setting instruction before using this device 

 

CHARGER LOCATION:

 

 

This is a wall mounted charger, locate charger as far away from battery as output DC cables permit. 

 

Never place charger directly above battery being charged; gases from battery will corrode and damage 

charger. 

 

Never allow battery acid to drip on charger when reading specific gravity or filling battery. 

 

Do not operate charger in a closed-in area or restrict ventilation in any way. 

 

Not designed for installation in caravans or similar vehicles. 

 

OUTPUT DC CONNECTION PRECAUTIONS:

 

a)

 Connect and disconnect DC output terminals only after switching the AC mains off.

 

b)

 Never allow DC output terminals to touch each other.

 

 

If you have any questions, problems with programming, connecting the output leads  

or anything else, please contact the Dealer from whom you purchased this product from.  

REMEMBER the only dumb question is the one you don't ask!

 

 

Содержание BCS12V1A









Отзывы: