BLQ32SVF AND BLQ36SVF BRICK
LINER KIT
INSTALLATION INSTRUCTIONS
www.fmiproducts.com
36" Fiber Panel Kit BLQ36SVF
IMPORTANT:
Read entire instruction sheet before installing brick liner
This brick liner accessory is approved for use in VFS32NRK/PRK and VFS36NRK/PRK vent-free gas fireplaces. Do not use brick
liner accessory in any other fireplace models.
Description
Rear Panel
Right Side Panel
Left Side Panel
Retainer Brackets
#10 Screws
Part No.
126383-04
126383-06
126383-05
116531-01
Qty.
1
1
1
2
4
Description
Rear Panel
Right Side Panel
Left Side Panel
Retainer Brackets
#10 Screws
Part No.
126377-04
126377-06
126377-05
116531-01
Qty.
1
1
1
2
4
The Brick Liner Kit contains the following:
32" Fiber Panel Kit BLQ32SVF
Figure 1 - Removing Fireplace Screen
Screen
Assembly
Magnet
Bottom Panel
Assembly
Top Panel
Assembly
Top Outer Casing
Fireplace
Hood
1. To remove the screen push in on the bottom left and right
corners. The screen should spring forward, lift screen up off
the hinge brackets.
2. Remove logs. Remove the three screws that attach the log
base assembly to the fireplace. There are two on the front of
the base and the third one is located behind the base. Care-
fully pull the base forward as far as you can (see Figure 2,
page 2).
CAUTION: Do not pick up log base assembly by burners.
This may damage burners. Only pick up base by the grate.
WARNING: A qualified service person must connect and
disconnect fireplace to gas supply. Follow all local codes.
3. Install rear panel (small row of bricks at the top) by angling
the bottom of the panel into the fireplace and sliding it behind
the base. Be careful to not scratch the face of the rear panel.
Stand the panel straight up against the back of the fireplace
(see Figure 3, page 2).
Tools Required
•
Phillips Screwdriver
•
5/16'' Nut Driver
•
Flashlight
If any of these parts are missing or damaged, contact the dealer
where you purchase this kit. If they cannot supply original re-
placement parts call FMI PRODUCTS, LLC at 1-866-328-4537
for information.
IMPORTANT:
Always handle firebrick panels with two hands.
WARNING: Turn off, unplug, and let fireplace cool be
-
fore installing brick liner. Only a qualified service person
should service and repair fireplace.
NOTICE: You must remove logs before installing brick liner.
