FM ST Series, Инструкция по эксплуатации

Страница: 38 / 48

38
Mod. B4600Humid
12.4 Vapour exhaust from the baking chamber
Exhaust gases may be wet and reach high temperatures. Therefore, do not use tubes made of materials not
ensuring absolute thermal stability up to 250ºC to channel exhaust gases.
A condenser enabling the condensation of vapours and exhaust of those vapours into a drainage may be adapted
to treat cooking vapours.
Important: Do not channel the vapour exhaust from the cooking chamber more than 50 centimeters due to risk of
condensation. This pipeline should be vertical and as straight as possible.
12.5 Gas connection
The connection to the gas supply network and the furnace connection installation must comply with the
regulations in force according to the country of installation of the equipment and must be trolleyried out by qualified and
authorized personnel.
Failure to comply with these regulations may cause damage and injury, resulting in the immediate invalidation
of the guarantee and exempting FM from any responsibility.
Before proceeding to the connection, check that the type of gas to be used, as well as the pressure of this,
correspond to the configuration of use of your oven, which is indicated on the characteristics label of the oven. If there is
a high pressure in the gas network, it will be necessary to install a pressure reducer upstream of the gas supply point of
the furnace. Otherwise, the oven components may suffer irreparable damage.
Unless expressly requested, the oven is pre-configured at the factory for use with LPG, butane (G30) or propane
(G31) gas and at a nominal pressure of 30mbar and 37mbar, respectively. Any change that is desired to be made in the
furnace after the acquisition of the same, such as, for example, the adaptation to the use of another type of gas, must be
made by a qualified technician and qualified for this purpose.
The connection to the gas network must be trolleyried out by means of a flexible tube, using ¾ ”connections at
the furnace connection point and inserting a cutting key upstream of it.
GAS ACCES POINT
MATERIAL NOT SUPPLIED