FM HARBIL 24018, Инструкция пользователя

Страница: 56 / 81

REASSEMBLING MIXER
56 Fluid Management
®
REASSEMBLING
MIXER
Two people are required to lift the shake frame into the mixer.
1. With one person on each side of the shake frame, lift the shake frame
into the mixer and rest it on the crankshaft. NOTE: the four (4) screw
holes in the swivel rods must be properly aligned with the holes in
the inner frame. The second person supports the top of the shake
frame so it will no fall forward.
2. Place the washers on the screws and insert them into the swivel rods.
Guide the screws into the holes in the inner frame. NOTE: The screws
are inserted from the inside of the swivel rods.
3. Place the nuts on the screws, but do not tighten them all the way. Repeat
steps 2 and 3 on the other side of the mixer.
4. Before mounting the flange bearings, lubricate them with lithium-based
grease.
• Rotate the collar of the flange bearing so that the two (2) set screws
are facing up, then place the flange bearing on the end of the
crankshaft.
• Tighten the set screws holding the crankshaft to the flange bearing.
• Use the 2" x 4' board to lift the shake frame in order to tighten the
four (4) nuts securing the flange bearing to the shake frame.
• Insert the screws from the inside of the shake frame, then place the
washers and nuts on the outside of the flange bearing and hand
tighten.
5. Standing in front of the mixer, verify that the shake frame is centered
inside the inner frame. There must be equal clearance between the shake
frame and the inner frame on both sides of the mixer. Adjust if
necessary.
6. Tighten the four (4) nuts and screws holding the swivel rods to the inner
frame. Insert the wrench on the inner side of the shake frame and tighten
one screw on the right and left sides. Again verify that the shake frame is
properly centered before tightening the other three (3) nuts all the way
on each side of the mixer.
7. Reinstall the inner frame weights.