FM HARBIL 24018, Инструкция пользователя

Страница: 36 / 81

CHANGING SHAKE MOTOR
36 Fluid Management
®
CHANGING
SHAKE MOTOR Read all of the following instructions. If you have any doubt about
performing these procedures, please contact Customer Service at Fluid
Management.
Turn to the Parts Section of this manual for component identification and
location.
1. Unplug the electrical cord.
2. Remove lower front and right/left side panels.
3. Make a drawing of the wire to the terminal connections, then disconnect
the wires from the shake motor.
4. Remove the four (4) hold-down screws on the motor.
5. Remove the V-belt from the pulley on the motor.
6. Remove and replace the motor.
7. Remove the pulley from the old motor by loosening the set screw.
8. Reposition the wires on the new shake motor by following the drawing
made in Step 3.
9. Reinstall the pulley on the new motor.
10. Put the V-belt on the balance groove pulley, then on the motor pulley.
11. Align the motor pulley with the groove pulley on the crankshaft.
12. Install and tighten down the four (4) motor hold-down screws while
keeping tension on the belt.
13. Be sure to adjust the shake motor for proper tension on the V-belt.
The deflection should be approximately 3/16" at five (5) pounds of
pressure.
14. Reassemble the paint mixer by reversing these instructions.
15. With a paint container in position, perform a test run of the mixer to be
sure that it is operating correctly.