EN
57
TR
IM
M
IN
G
Bring the C-Leg up to the A
and Z legs and tension the mi-
xer. All three knots should be at
the same level at standard trim.
If this is not the case, you just have to
move the metal ring of the mixer (C-Leg)
until all 3 knots are at the same level.
Tip
: The mixer is basically
a 2-1 pulley system. If you
want to change the B-Leg
by one centimeter, you will
need to move the ring by
two centimeters.
Bring the B-Leg up to the A, C and
Z legs and tension the mixer. All four
knots should be at the same level
at standard trim.
If this is not the case, you just have to
move the metal ring of the mixer (B-Leg)
until all four knots are at the same level.
Done. Be sure to pull everything
properly tight again after adjusting, so
that the trim stays under tension.
Tip:
When the mixer is set to
the standard trim (0), e.g. all
four knots are at the same
level. It is enough to only
move the metal ring of the
mixer (C-Leg) to change the
basic trim. The B-Leg
automatically adjusts half
the amount of the C-Leg
when modifying.
13.02 Optimum trim
of the flying lines
Steering (back) lines shorten over time
in relation to the flying (front) lines.
Underneath the floaters, the back line
can be shortened or extended by using
knots. Extension of the back lines is
necessary when the trimmer needs to be
pulled in too much to keep the kite flying
normally in its intended wind range.
Содержание SONIC FR Series
Страница 1: ...GEAR GUIDE...
