FS-G7P
Digital Proportional Radio Control System
Website
20
6.26 Receiver Settings -i-BUS Settings FS-CEV04
The i-BUS SET(i-BUS setting) function is a unique and powerful serial communication protocol
system provided by FLYSKY. It can be output to any channel by setting.For receivers with i-BUS
interface and corresponding accessories, see the description of serial bus receivers for details.
Function settings:
1.
The transmitter and receiver are completed successfully;
2.
Connect the input cable of the FS-CEV04 Serial Bus Receiver to the SERVO port of the receiver;
3.
Connect the servo to the C1-C4 ports of the FS-CEV04 Serial Bus Receiver;
4.
Turn on the transmitter to enter the i-BUS SET interface, and select the channel to be
assigned; if the channel is incorrect, select "CANCEL" to re-set;
Note: If the interface prompts to set the RF type to "ANT TWO WAY" first, set the RF type to ANT
TWO WAY first.
5.
Press the corresponding button on the i-BUS receiver. After the setting is successful, the
system will pop up a pop-up window showing the interface number of the currently selected
channel assigned to the i-BUS receiver.
6.
Repeat the above steps to set more channels.
Note: If the receiver is overloaded, please supply power separately to prevent the wire from being
burnt out due to excessive current.
Three parameters, namely operating mode, battery type, and drag braking force can be setup
here.There are two braking modes as follows: the first mode is FOR/BRK/REU that means, the
device moves forward when pressing the trigger for acceleration; it is braked when pulling the
trigger backward and then reverses when releasing the trigger to the neutral position and then
pulling it backward again; and the second mode is forward/reverse that means, the device moves
forward when pressing the trigger for acceleration, and it reverses immediately when pulling the
trigger backward.These two modes can be set according to actual needs.
Function settings:
1.
In the ESC SET menu, select the item to be adjusted by pressing the UP/DOWN key and press
the OK key for editing. Set the desired value by pressing the UP/DOWN key and press the OK
key to confirm the adjustment.
2.
After that, carry out a test to confirm that all set channel outputs are functioning as expected.
6.27 Model
The MODEL menu is used for model management. It includes four options: select model, model
name, copy model and reset model.
SELECT: The transmitter can save up to 20 sets of model data, and you can call out one set of
model data at any time and use it as needed.
NAME: The name of the model you select can be edited and changed.
COPY: If you have a new model that is the same or similar to the model you used before, you can