Website
17
Danger
• For safety always power off the receiver before the transmitter.
5.6 Neck Strap Hook and SD Card Slot
To access the card slot, need to remove the Neck Strap Hook first.
The steps are as below：
1.
loosen the two hex screws on the back Neck strap hook.
2.
Remove the Neck strap hook to expose the SD card slot.
3.
Press the SD card inwards and release to remove.
SD card slot
Note: The EL18 transmitter needs to have an SD card installed for
the firmware to work correctly.
5.5 Power Off
5.7 Warning After Turning On
Follow the steps below to turn off the transmitter：
1.
Turn off the receiver.
2.
Press and hold both Power Switches until the screen turns off.
Press and hold the Power Switches to turn on the transmitter. Before entering the radio interface, the system will check
the position of the throttle stick and controls, as well as other starting conditions. There will be a corresponding error
warning which needs to be cleared by user operation or skipped by pressing any key, when the conditions do not match.
If the throttle stick is not in the lowest position when
turning on, this warning will appear. Then put the throttle
stick to the lowest position or press any key to skip.
This is a warning that the controls are not in their default
position. ↑ is the default position.
Throttle Warning
Control Warning
