Pluswing Series
Instruction Manual
Shadow Depron Aero
Specifications
Fuselage length: 853mm(33.5in)
Wingspan: 820mm(32.3in)
Flying Weight: 120-150g(with battery)
Additional Required Equipment
Motor:1804-2204
ESC: 6A
Propeller: 8043
Aileron Servo: 8-9g
rudder servo and elevator servo
：
4-5g
Radio:4/more channel
Receiver: 4/more channel
Battery charger
Battery: 7.4V 200 mAh -400mAh Li-po
Advantage Points
·Genuine 3mm Depron Aero from Europe for best flight performance
·Lightweight carbon fiber truss system virtually eliminates flex
·Minimal assembly required flight ready in as little as 2 hours
·Ideal for indoor flight and capable of outdoor flight in low winds
·Gorgeous and vibrant printed pattern
Introduction
Thank you for purchasing the Shadow Depron-Aero, it belongs to our
Pluswing Series which has the best design and the most advanced
technology. Shadow is made of Depron-Aero, the wonderful foam for
airplanes models, with this ideal material Shadow is very flexible in the air, it
can achieve many difficult 3D moves. The Shadow was reinforced with the
best carbon rods, so it provides precise and solid feel. With flyrace’s
advanced design Shadow Depron-Aero can be easily and quickly built.
The assembly instruction can help to assemble your new airplane in the
shortest possible time. You can get many basic tips from assembling a
new Plane. Please assemble the model according to the instructions as
below.
Required Tools and Adhesives
(not included in the kit)
5 Minute Epoxy Resin
Depron Friendly Glue
Uhu Por
#0 and #1 Phillips Head Screwdrivers
1.5 mm Hex Wrench
Adjustable Wrench
Wire Cutters
Z-Bend Pliers
Needle Nose Pliers
Modeling Knife
Scissors
Electric or Hand Drill
Assorted Drill Bits
Straight Edge Ruler
Pencil
Builder’s Triangle
220 Grit Sandpaper with Sanding Block
Masking Tape
Paper Towels
Rubbing Alcohol
Epoxy Mixing Sticks
Epoxy Mixing Cups
