FLYINGVOICE
Page 9 of 86
5) After the sequence, the phone will display date & time, lines status for the phone, and FIP11/FIP11W/FIP11WL is started normally.
Note: If the phone does not provide this screen, re-confirm installation and connections. If these are incorrect, try unplugging the
phone and plugging it back in again. If you still don’t see the display, then contact your Phone Administrator or service provider.
2.4 Connect to the Internet
You can connect the FIP11/FIP11W/FIP11WL to the Internet via wired and via wireless.
2.4.1
Via Wired
Step
1.Check
FIP11/FIP11W/FIP11WP/FIP11P
have
powered
on
correctly.
Step
2.Plug
the
Ethernet
cable
into
Internet
port
in
the
rear
side
of
the
base
station.
Plug
the
other
end
of
the
Ethernet
cable
into
your
already
prepared
network
connection.
Step
3.After
the
sequence,
the
IP
Address
of
Internet
port
will
appear
at
the
bottom
of
the
LCD.
2.4.2
Via Wireless (FIP11 do not support wireless)
You can configuration wireless from LCD menu and from webpage.
From LCD menu:
Step 1.Press the
button, and then select
13Wireless
using the
UP and DOWN button
.
Step 2.Choose
2Wireless Connection
and you can view the wireless then FIP11/FIP11W/FIP11WL can connect to.
Step 3.Highlight one network using the
UP and DOWN button
, and press the
softkey button under link
to connect.
Note: If the Wi-Fi need authentication, choose the authentication and fill in the password.
Step 4.Press the
softkey button under ok
to confirm connecting.
Step 5.If the AP has connected, the wireless icon in LCD will display linked.
