Fluval 07 series, Руководство пользователя

Страница: 12 / 116

EN-9
3. Reassemble unit – DO NOT FILL CANISTER WITH WATER WHEN RE-ASSEMBLING UNIT
1. Place rinsed and filled media baskets back in canister and put cover back on top basket.
2. Replace pre-filter basket in canister. (Insert with flat end down.)
3. Always lubricate motor head gasket using an inert lubricant (i.e. Fluval Silicone Lubricant #A325 or vegetable oil).
4. Replace the cover.
Be sure to position it properly. There is only one orientation possible.
5. Use the lock-lift clamps to close the cover securely.
6. Place the unit back in position; re-insert the AquaStop valve,
and push down the locking lever to lock it in place.
7. Push down on the valve lever to open the AquaStop valve. Water should start flowing immediately.
IMPORTANT: If the hosing has been disconnected from the AquaStop valve, or if the system has lost its vacuum for some
other reason, the canister will not fill automatically. Use the instant-prime handle to fill the canister.
8. Allow the canister to fill completely, then plug the power cord back into the electrical outlet.
IMPORTANT: If the canister is not full before the filter is plugged in, it may not work properly. The filter unit should never be
allowed to run dry. Running the unit dry may result in damage to the motor.
Impeller Care
The impeller well has an effective self-cleaning feature. However, it is recommended that you remove the impeller cover and inspect
the impeller as part of your routine maintenance. Keeping the impeller clean lengthens its life and the life of the motor.
IMPORTANT: The impeller fan has a ceramic shaft, which is resistant to wear and tear
in use, but is still fragile. Handle carefully during maintenance.
1. Remove the impeller cover: Pull the tab over and gently pry off.
2. If the impeller needs cleaning, grasp the fan and draw it gently from the well.
Rinse it under clean water.
3. If the well needs cleaning, wipe gently with a Fluval Cleaning Brush.
4. Replace the impeller in the well: Slide the impeller cover tab into the tab receptacle on the rim of the impeller chamber. Push
down the opposite side of the impeller cover making sure the impeller starts to seat
itself in the center of the impeller cover. Continue to push down until the retailing
tab “clicks” and locks into position.
NOTE:
The ceramic impeller shaft is held on the bottom of the impeller well by a rubber
support. The shaft can be easily extracted and reinserted by hand; however, pay close
attention to be certain the rubber support does not become unseated. (Always replace
the impeller cover to ensure proper alignment).
The impeller will wear out over time. A replacement may be ordered from your local
Fluval dealer or by contacting
Fluval/Rolf C Hagen Inc. customer service.
Primer
Please note Primer handle can only be replaced in the event of breakage of the stem or
handle.
click!
Recycling
This product bears the selective sorting symbol for waste electrical and electronic equipment (WEEE).This means that
this product must be handled pursuant to European Directive 2012/19/EU in order to be recycled or dismantled to
minimize its impact on the environment. Check with your local Environmental Agency for possible disposal instructions
or take to an official council registered refuse collection point.
Electronic products not included in the selective sorting
process are potentially dangerous for the environment and human health due to the presence of hazardous substances.
MAINTENANCE