Fluke Versiv, Руководство пользователя

Страница: 166 / 260

Versiv Cabling Certification Product Family
Users Manual
152

The percentage of the tests in the project that are completed.
The tester uses the number of available IDs and the tests you
selected on the
CABLE ID SETUP
screen to calculate this
percentage. See Figure 86 on page 216.
% Tested
does not
show if your project contains only a
Next ID
list. See “About
Next ID Sets” on page 215 for more information about the
Next ID
list.

The type of module attached to the tester. If no module is
attached, this screen shows
HOME
.
Settings for OTDR Tests
Table 7 gives descriptions of the settings for OTDR tests. To set up
a project, which includes the settings in Table 7, cable IDs, and
operator names, see Chapter 11.
To set up an OTDR test
1
On the home screen, tap the test setup panel.
2
On the
CHANGE TEST
screen, select an OTDR test to change,
then tap
EDIT
.
Or to set up a new OTDR test, tap
NEW TEST
then tap a
Test
Type
.
3
On the
TEST SETUP
screen, tap the panels to change settings
for the test. See Table 7.
4
On the
TEST SETUP
screen, tap
SAVE
when your test setup is
completed.
5
On the
CHANGE TEST
screen, make sure the button next to
the test is selected, then tap
USE SELECTED
.