Quick
Start
:
Fluke TiX 500/520/560
© 2015 The Snell Group / 322 N. Main St. / Suite 8 / Barre, VT 05641 / 800.636.9820
/
www.thesnellgroup.com
Fluke TiX-500-560
NOTE:
To access the menu on the TiX520 or 560 you may use the F2 button or simply touch the LCD screen.
Either method will bring up the menu. To navigate the menu, you may use either the directional arrow buttons,
the touchscreen, or a combination of the two.
1.
MEMORY:
Insert SD memory card into the slot under the rubber cover on the bottom of the camera.
2.
POWER:
Insert a fully charged battery into the slot on the bottom of the camera. The slot is on the left side of the
camera near the hand strap. The battery life is indicated in the lower left corner of the LCD display. You can also press
and hold the battery symbol on the side of the battery.
3.
START:
Press the Power button until you see the LCD screen become active signaling camera startup.
Remove the lens cap from the front of the camera.
Once the camera finishes booting up, you will see the default start up screen showing a live infrared image.
To turn the camera off, press the Power button until you see the LCD screen go dark, signaling it is powering
down.
4.
FOCUS:
Focus is either manual or automatic, and is user selectable.
Manual—adjust adjust the focusing ring either clockwise (farther away) or counter clockwise (closer) to optimize
image focus.
Automatic—focus is laser enhanced. To utilize, depress the top/black button while aiming the laser at the object
of interest. While holding the camera steady, release the button. If there is too much movement of the laser during
the auto focusing operation, an
Excessive Laser Movement
warning may appear on the screen,
5.
AUTO ADJUST (Level and Span):
Auto Level and Span can be selected three ways. If operating in Manual
Mode, depress and hold the F1 button and the imager will change to Auto mode.
Press the Auto/Manual button located in the middle of the control panel (see above image) to select between Auto
and Manual modes.
Auto mode is additionally accessible through the menu screens. Open the menu and select
Measurement.
Then
select
Set Level/Span
. To select auto, either press the
Auto
button on the screen, or highlight it with the directional
buttons and then depress
Select
and then
Done.
Memory
Card Slot
Battery
Directional
Arrow Keys
Image Capture
Button
Laser
Distance
Finder
F1, F2, F3
and On/Off Power
Button
IR Fusion
Flashlight
Memory
Auto/Manual
Mode Select
Rescale
Zoom
Manual
Focus
Ring
AC Charger, HDMI out,
USB, Mini-USB
WiFi
