Fluke RUSKA 7750i, Руководство пользователя, Страница: 58 / 106

RUSKA 7750i
Users Manual
5-2
RS-232
The RS-232 interface supports standard serial operation from a computer to a single
ADTS. RS-232 supports the IEEE-488.2 and SCPI commands. The ADTS allows
the following port setups:
Baud Rate: 1200, 2400, 9600, or 19200
Data Bits: 7 or 8
Parity: Even, Odd, or None
Stop Bits 1 or 2
Handshaking XON/XOFF
The RS-232 connection is a DB-9P connector found on the back panel of the ADTS.
It is located on the processor board. The following pins are used; all other pins are
reserved.
Pin # Direction Signal
2 In RXD Receive Data
3 Out TXD Transmit Data
5 —— GNDGround
7
Out RTS Request to Send
Remote/Local Operation
In Local mode, the ADTS is operated manually through the front panel. Chapter 4
covers local operation. The ADTS always powers up in the Local mode. In Remote
mode, the ADTS is operated by a computer connected to an interface. Most
functions that can be performed in Local mode can also be performed remotely.
Remote mode does not automatically disable local operation. The remote interface
may be active while local operations are being done. In cases where full remote
control is required, the following methods may be used.
1. Issue a Local Lockout (LLO) interface message via the IEEE-488 interface.
The ADTS will disable the local keyboard until the Go To Local (GTL) interface
message is received or the REN (Remote Enable) line is unasserted. This method
cannot be used on the serial interface.
2. Issue the SCPI command “SYSTEM:KLOCK ON” to lock the local keyboard.
The ADTS will disable the local keyboard until the command “SYSTEM:KLOCK
OFF” is received.
3. Issue the SCPI command “DISPLAY:ENABLE OFF” or “DISPLAY:TEXT
<string>.” These commands will disable the local display in addition to locking
the keyboard. The command “DISPLAY:ENABLE ON” will restore the local display
and keyboard operation.
Local operation may also be restored by turning the ADTS off and back on.