Fluke molbox RFM, Руководство по эксплуатации и обслуживанию

Страница: 110 / 172

molbox™ RFM™ OPERATION AND MAINTENANCE MANUAL
© 1998-2007 DH Instruments, a Fluke Company Page 100
Table 22. Error Messages
REPLY DESCRIPTION
ERROR “The molbox RFM is in high security level and cannot accept remote commands”
ERR# 0 “OK”
ERR# 1 “molbloc flow is too great”
ERR# 2 “Text argument is too long”
ERR# 3 “User defined coefficient cannot be 0”
ERR# 4 “External device not detected”
ERR# 5 “External device improperly configured”
ERR# 6 “Numeric argument missing or out of range”
ERR# 7 “Missing or improper command argument(s)”
ERR# 8 “External device timeout error”
ERR# 9 “Unknown command”
ERR# 11 “Command missing argument”
ERR# 12 “System overpressured”
ERR# 13 “Text detected in numeric field”
ERR# 14 “User unit not defined”
ERR# 15 “Averaging cycle not started”
ERR# 17 “Selected gas not available”
ERR# 18 “Command not yet available”
ERR# 19 “Not supported”
ERR# 20 “Not supported”
ERR# 21 “User device not defined”
ERR# 22 “Pressure is not stable”
ERR# 23 “Option not available or installed”
ERR# 24 “molbloc not detected”
ERR# 25 “Transducer out of calibration”
ERR# 26 “COM port failed to initialize”
ERR# 27 “Internal device #1, 2 or 3 timeout error’
ERR# 29 “Busy averaging”
ERR# 30 “Fatal mass flow calculation error”
ERR# 31 “molbloc EEPROM is full”
ERR# 32 “molbloc gas not found”
ERR# 34 “molbloc is write protected”
ERR# 35 “molbloc write error”
ERR# 37 “Gas table is full”
ERR# 38 “Selected range not available”
ERR# 39 “molbloc verify error”
ERR# 40 “molbloc read error”
ERR# 41 “molbloc invalid”
ERR# 42 “PRT measurement error”
ERR# 44 “Entry already exists”
ERR# 45 “Argument not allowed”
ERR# 46 “The leak is too large”
ERR# 47 “Temperature change was too great”
ERR# 48 “Offset was excessive. Check tare ”
ERR# 49 “Possible upstream leak”
ERR# 50 “Possible downstream leak”