Fluke E1M, Руководство пользователя

Страница: 69 / 147

PROFINET IO
Input Data
69
9
9.4 Input Data
Table 9-3: Input Data
Address without offset Length Format Value
0 4 Byte REAL (Big Endian, Motorola) Target Temperature 2 color
4 4 Byte REAL (Big Endian, Motorola) Target Temperature 1 color wide
8 4 Byte REAL (Big Endian, Motorola) Target Temperature 1 color narrow
12 4 Byte REAL (Big Endian, Motorola) Internal temperature
16 4 Byte DWORD Error Code
20 1 Byte BYTE Bit0 (Bool) Trigger state (0
– reset, 1 – set)
21 2 Byte INT (Big Endian, Motorola) Measured attenuation
9.5 Output Data
The output data may be used to change the initialization of the device (which was set once at start-up) when the
bus is in data exchange mode.
Table 9-4: Output Data
Address without offset Length Format Value
0 1 Byte BYTE Type of parameter
1 4 Byte REAL/ WORD Parameter
The <Type of parameter> gives the meaning of the following parameters with the same format as described in
section 9.2
Parameters , page 67.
Table 9-5: Parameter Types
Type of parameter Meaning Format
0 Do not change anything
1 Slope REAL
2 Emissivity REAL
3 Transmissivity REAL
4 Averaging time REAL
5 Peak hold time REAL
6 Valley hold time REAL
7 Set point for the relay REAL
8 Laser control WORD
If <Type of parameter> is set to 0 then the output data gets ignored. As default, it should be set to 0 (zero).
9.6 Diagnostics
The diagnostics information of the fieldbus communicator can be read out acyclically using standard diagnostics
data sets defined in the PROFINET IO specification.
Errors occurring when configuring and setting the parameters of the fieldbus communicator and the connected
pyrometer as well as external errors are reported by the communicator via channel specific diagnostic.