Fluke CableAnalyzer DSP-4100, Руководство пользователя

Страница: 50 / 216

DSP-4000 Series
Users Manual
2-30
•
Select a frequency for the power line noise filter.
•
Set the fault threshold for the impulse noise test.
•
Enable or disable the test tool’s beeper.
•
Modify test standards for custom test configurations.
•
Select a remote end configuration when a Fiber Test Adapter is attached.
Print
Allows you to send saved reports or report summaries to a serial printer. You can
print the results from previously stored Autotests. Also lets you edit the report
identification information and select a format for Autotest reports sent directly to a
printer.
Special Functions
Allows you to do the following:
•
View or delete test reports saved in memory.
•
Change the cable identification assigned to a saved Autotest report.
•
Generate a tone to use with an inductive pickup device, such as the Fluke
Networks 140 A-Bug Tone Probe, to identify cabling runs.
•
Determine the cable NVP to ensure maximum accuracy of length results.
•
View the status of the NiMH battery in the main unit or remote.
•
Check the status of the LIA attached to the main or remote unit.
•
Perform a self-calibration on the test tool and remote.
•
Run a self-test to verify proper operation of the test tool, link interface adapter,
and remote.
•
On DSP-4100 and DSP-4300 test tools, you can view the status of the memory
card and format the card.
•
View version information for the main and remote units.