Fluke CableAnalyzer DSP-4000 Series, Руководство пользователя

Страница: 89 / 228

Autotest
Saving Autotest Results
3
3-29
If you try to save an Autotest after the last ID in the range has been used, the list of
saved reports shows that no IDs are available (all are marked with a “$”). To save
additional results, set up a new range of IDs in SETUP, or use the
! Edit
or
@ New
softkey as described above to create a new ID for each additional
Autotest.
Changing the Cable ID for a Saved Autotest Report
You can change the cable identification assigned to a saved Autotest report as
follows:
1. Turn the rotary switch to SPECIAL FUNCTIONS.
2. Select
View/Delete Test Reports
.
3. Use
D U
to highlight the desired report. Press
@ View Result
, then
press
! View Result.
4. Press
@ Rename Report
. Use the editing softkeys to edit the cable
identification (refer to the softkey descriptions in Figure 3-10).
5. Press
S
.
If Memory is Full
If the Autotest results you save fill the last available memory location, the
following message appears:
WARNING! TEST RESULT MEMORY IS
NOW FULL
. If you try to save additional test results after the memory has been
filled, the following message appears:
UNABLE TO SAVE TEST
RESULTS. MEMORY IS FULL
.
To save additional test results, you must delete one or more test reports from
memory (in SPECIAL FUNCTIONS mode) or, for a DSP-4100 test tool, put a
new multimedia card in the test tool. To transfer test reports to a PC, use the
CableManager software included with your test tool. See the CableManager
Appendix for details.
You can see how many memory spaces are available by pressing the
Memory
softkey, which appears on several Autotest displays.