Fluke 990DSL, Руководство пользователя

Страница: 43 / 242

Setting Up and Operating the CopperPro
The Menus
3
3-5
Auto-Test Setup Menu
To display the setup menu for an Auto-Test, do the following:
1. From the
Main
menu (Figure 3-1), press
H
to select the desired Auto-
Test.
2. Press
D
(
Setups
).
The
Setups
menu for the Auto-Test you selected is displayed.
Toolbox Test Setup Menu
To display the setup menu for a test in a toolbox, do the following:
1. From the
Main
menu, press
A
(
POTS
),
B
(
XDSL
), or
C
(
TDR
).
A menu of tests in the selected toolbox is displayed.
2. Select the test that you want to set up. Then, press
D
(
Setups
).
The
Setups
menu for the test is displayed.
Generic and Test-Specific Setup Parameters
Figure 3-3 shows a typical setup menu for a toolbox test (VF Noise). Every
setup menu has two groups of parameters. At the top of the screen is the first
group, which consists of three generic parameters (described in Table 3-1).
The parameters are considered “generic” because they apply to
all of the
CopperPro’s tests.
You can change the value of a generic parameter from any setup screen (see
“Editing the Setup for a Test”). Just be aware that when you save the change, it
is stored in the tester’s memory and applies to
every CopperPro test.