Fluke 9640A Series, Инструкция по эксплуатации

Страница: 201 / 324

Calibration
Performance Test
5
5-11
Table 5-3. Harmonics Test
Level Frequency
2
nd
Harmonic
Tolerance
3
rd
Harmonic
Tolerance
20 kHz 40 kHz -60 dBc 60 kHz -60 dBc
2.74 MHz 5.48 MHz -60 dBc 8.22 MHz -60 dBc
5.5 MHz 11 MHz -60 dBc 16.5 MHz -60 dBc
11 MHz 22 MHz -60 dBc 33 MHz -60 dBc
22 MHz 44 MHz -60 dBc 66 MHz -60 dBc
32.38 MHz 62.5 MHz -60 dBc 93.75 MHz -60 dBc
44 MHz 88 MHz -60 dBc 132 MHz -60 dBc
62.5 MHz 125 MHz -60dBc 187.5 MHz -60dBc
88 MHz 176 MHz -60 dBc 264 MHz -60 dBc
+24 dBm
125 MHz 250 MHz -60 dBc 375 MHz -60 dBc
250 MHz 500 MHz -60 dBc 750 MHz -60 dBc
354 MHz 708 MHz -60 dBc 1.062 GHz -60 dBc
500 MHz 1 GHz -60 dBc 1.5 GHz -60 dBc
714 MHz 1.428 GHz -60 dBc 2.142 GHz -60 dBc
1 GHz 2 GHz -60 dBc 3 GHz -60 dBc
+20 dBm
1.4 GHz 2.8 GHz -55 dBc 4.2 GHz -55 dBc
1.8 GHz 3.6 GHz -55 dBc 5.4 GHz -55 dBc
2.7 GHz 5.4 GHz -55 dBc 8.1 GHz -55 dBc
+14 dBm
4.024 GHz 8.048 GHz -55 dBc 12.072 GHz -55 dBc
16. Set the output frequency of the UUT and the spectrum analyzer center frequency to
each of the frequencies listed in Table 5-4, repeating steps 14 through 15.
17. Set the UUT output to
STBY
. Leave the connections intact for use in the following
test, if desired.
Table 5-4. Spurious Content Test
Output Frequency Tolerance
2.1 GHz < -60 dBc
2.199 997 GHz < -60 dBc
2.200 003 GHz < -60 dBc
2.399 997 GHz < -60 dBc
2.5 GHz < -60 dBc
2.600 003 GHz < -60 dBc
2.7 GHz < -60 dBc
2.799 997 GHz < -60 dBc
2.800 003 GHz < -60 dBc
3.0 GHz < -60 dBc
3.199 997 GHz < -60 dBc
3.200 003 GHz < -60 dBc
3.400 003 GHz < -60 dBc
3.599 997 GHz < -60 dBc
3.800 003 GHz < -60 dBc
4.0 GHz < -60 dBc