Fluke 9132A, Руководство по обслуживанию

Страница: 45 / 92

9132A Service
3-14
Figure 3-8.
Service
Test
Program Menu
The tests prompt you for information on the Pod configuration whenever
necessary, or for operator
steps.
The Service Test stops whenever the first
failure is found. To return
to
the main menu after the test has stopped,
press ENTER/YES.
Whenever a failure is located, the Service Test stops and
shows
an
error
message on the Mainframe display. The error message indicates the type of
failure that has occurred
and
the general area
in
which the cause of the
failure can most likely be
found.
Once the failure has been corrected, the
Service Test program should be run again
to see
if
any other failure can be
found.
The following paragraphs describe each part of the Service Test and the
sub-
functional tests that are associated
with them:
1.
Main Board Full Functional Test
The Main Board Full functional test menu selection runs the full
functional
test.
The following sub-functional tests are run during the
Main Board Full
function
test:
Bus Test
Kemel ROM
Kernel RAM
Emulation RAM
Personality Module
State Machine
Sync Module
Bank Swap Circuit
Address Comparator
ROM Module
RUN UUT Circuit
Address RAM
Clock Fail Circuit
Cal Test Point
Mainframe Port
ROM Module 2,
3, and
4
©
0
4
+
6
0
0
0
4
eo
es
4
0
+»