High-Pressure Modular Controller
Error Codes
61
Error Codes
If an error occurs during Product operation or control, an error message is shown
on the display. Errors can be caused by:
Incorrect control that uses the front panel, (for example, attempts to force a
prohibited mode or overloading of output terminals)
Product fault.
These messages are shown in Table 20. All error messages are shown in a
frame that overlaps the main screen. Alternately, error messages can be read
and cleared over the remote interface using the SYST:ERR? command. If the
error is slot or sensor specific, an additional number may be appended to the
reply.
Table 20. Error Codes
Error Number
Error Message
0
No Error
103
Invalid Separator
104
Data Type
109
Missing Parameter
110
Command Header
113
Command Unknown
114
Header Suffix
201
Remote Required
221
Settings Conflict
222
Out of Range, Setpoint is above or below the Safety Limits of the controller, or the
Range of the active module.
281
Cannot create program
282
Illegal Program Name
284
Program Currently Running
285
Program Syntax Error
286
Program Runtime Error
313
Calibration Data Lost
315
Configuration Data Lost
330
Self-Test Failed
350
Queue Overflow
400
Query Error
500
Controller Malfunction
501
High Limit Exceeded, Pressure is above Safety Upper Limit
502
Low Limit Exceeded, Pressure is below Safety Lower Limit
503
Slew Limit Exceeded
