8270A/8370A
Operators Manual
2
Safety Information
A
Warning
identifies conditions and procedures that are dangerous to the user.
A
Caution
identifies conditions and procedures that can cause damage to the
Product or the equipment under test.
XW
Warnings
To prevent possible electrical shock, fire, or personal injury:
Only assemble and operate high-pressure systems if you
know the correct safety procedures. High-pressure liquids
and gases are hazardous and the energy from them can be
released without warning.
Read all safety information before you use the Product.
Carefully read all instructions.
Do not use the Product around explosive gas, vapor, or in
damp or wet environments.
Do not operate the Product with covers removed or the case
open. Hazardous voltage exposure is possible. Pressure
modules may be exchanged through the front panel while
the Product is turned on.
Use this Product indoors only.
Do not put the Product where access to the mains power
cord is blocked.
Use only the mains power cord and connector approved for
the voltage and plug configuration in your country and rated
for the Product.
Make sure the ground conductor in the mains power cord is
connected to a protective earth ground. Disruption of the
protective earth could put voltage on the chassis that could
cause death.
Replace the mains power cord if the insulation is damaged
or if the insulation shows signs of wear.
Use the Product only as specified, or the protection
supplied by the Product can be compromised.
Before the Product is used to apply pressure, ensure the
integrity of all components to be pressurized and make sure
they are rated to adequate working pressure.
Do not apply more than the rated voltage, between the
terminals or between each terminal and earth ground.
Do not touch voltages >30 V ac rms, 42 V ac peak, or
60 V dc.