63/66/68
Infrared Thermometers
18
Setting the High Alarm, Low Alarm, and
Emissivity (66/68)
To set values for the High Alarm (HAL), Low Alarm (LAL), and
Emissivity, pull the trigger or press
to activate the display.
Press
until the appropriate icon appears in the lower left of the
display. Use
or
to adjust the desired values. To activate
the alarms, press
. To deactivate the alarms, press
again.
Using a Contact Temperature Probe (PRB) (66/68)
XW
Warning
To avoid electrical shock or personal injury, do not
connect the optional external probe to live electrical
circuits.
Connect the probe to the input on the side of the unit. PRB
appears in the left of the display. The probe temperature appears
in the lower right of the display. The live infrared temperature
continues to show in the center of the display. While the probe is
connected, you may still cycle through the mode functions by
pressing
. See Figure 8.
Note
PRB is only available in the Function loop when a probe
is connected to the unit. The probe temperature will not
activate the high alarm or low alarm.
Temperature
Probe
ame009.eps
Figure 8. Connecting a Temperature Probe
