Fluke 6200-2, Руководство пользователя

Страница: 28 / 34

6200-2
Users Manual
20
Print Test Results
The print function prints all the stored results (first to last) to the optional Fluke printer.
Printing is disabled during any appliance test.
To print the results:
1. Connect the printer to the Tester USB type A connector.
2. Push

to start printing. The display shows the progress.
If the beeper sounds, and

is turned off when you push

, the Tester could not find the
printer. In this case, the idle screen does not show

.
If printing fails:
•
Verify that the Fluke printer is connected to the Tester and that the printer power is on.
•
Verify that you used the correct USB port.
•
Verify that the printer dip-switch settings are in the default position (see Fluke printer
Users Guide).
Maintenance
There are no user replaceable parts in the Tester.

Warning
To prevent possible electrical shock, fire, or personal injury:
•
Do not operate the Product with covers removed or the case open.
Hazardous voltage exposure is possible.
•
Disconnect the mains power cord before you remove the Product
covers.
•
Use only specified replacement fuses.
•
Use only specified replacement parts.
•
Have an approved technician repair the Product.
How to Clean
Periodically wipe the case with a damp cloth and mild detergent. Do not use abrasives or
solvents.
Dirt or moisture on the earth bond test lead plug can result in a contact resistance that affects
the readout. Periodically zero the earth bond test (see page 8).
Calibration
To ensure the accuracy of the Tester is maintained at a high level it is recommended that the
Tester is calibrated at least once every 12 months. Calibration must be carried out by
qualified personnel. Contact your local Fluke representative for calibration (see
How to
Contact Fluke on page 1).