Fluke 2680A, Руководство пользователя

Страница: 76 / 274

2680A/2686A
Users Manual
2-40
Reviewing and Setting the General Network Socket Port
Perform the procedure in Table 2-12 to review or set the general network Socket
Port (1024 to 65535). The default port is 04369. In order to communicate with
each other, a host computer and an instrument must use the same socket port
number. (See Figure 2-17 for examples.) Typically, the default port does not need
to be changed.
•
General Network Socket Port Enter the Socket Port supplied by your
network administrator.
Table 2-12. Reviewing and Setting the General Network Socket Port
F
Press the COMM key to review the network settings, or press and hold the
COMM key for 3 seconds to set the network settings.
C
B
Press the up/down arrow keys until nEt (Network) appears in the primary
display (COMM appears in the secondary display).
I
Press the ENTER key. nEt appears in the secondary display and ISo (isolated
network) or gEn (general network) is in the primary display.
C
B
To set the network type, press the up/down arrow keys to select gEn.
I
Press the ENTER key. (Pressing any other function key will cancel set
operations.) This displays the current Socket Port.
D
E
To set the socket port, press the left/right arrow keys to select the desired digit
position (highlighted).
C
B
Press the up/down arrow keys to select the desired number, 0 to 9, for the
positioned Port digit. In this manner, select all Port digits.
I
Press the ENTER key. This displays the first digit of the Internet Protocol
address segment IP:0.
I
Press the ENTER key to enter the settings and exit the procedure. (Pressing
any other function key will cancel set operations.).