Fluke Calibration P5515, Руководство пользователя

Страница: 11 / 28

Hydraulic Comparison Test Pump
Preparation
3
Table 1. Symbols
Symbol Description
B
AC (Alternating Current)
J
Earth Ground
W
Important Information: refer to manual
~
Do not dispose of this product as unsorted
municipal waste. Go to Fluke’s website for
recycling information.
Preparation
The comparison test pump must be set up on a level, stable workbench or similar surface.
Remove spokes from tool roll and fit to capstan hub.
Level the tester using the four adjustable feet to prevent “rocking”.
Rotate reservoir dust cover through ¼ turn and fill reservoir approximately ¾ full with
the appropriate fluid. Rotate dust cover back to cover hole.
W
Caution
To avoid damage to the instrument, the operator should check
the quality of the operating fluid during use. If the fluid
becomes discolored, cloudy or particles appear in the reservoir,
the system should be drained and flushed with clean fluid.
Operating Fluid Compatibility
W
Caution
The standard system is designed for use with a wide range of fluids,
however, the reservoir tube is Acrylic, and the O-ring seals are Nitrile; use
of solvents, fuel oils, brake fluids or other, similar aggressive fluids can
damage the seals and the reservoir tube .
The table below details the two alternative versions of this instrument, which offer
increased compatibility with other fluids.
Table 2. Increased Fluid Compatibility Models
Model O Rings Reservoir Tube
P5515 Nitrile Acrylic
P5515-V Viton Anodized Aluminum
P5515-EP Ethylene Propylene Anodized Aluminum
Connections
Fit the device under test (DUT) to the test port using the method described below:
W
Caution
Ensure that all devices are internally clean and free from
contamination before connecting to the tester.
Particle contamination can damage the sensitive piston
assemblies, valve seats and screw pump.