/ 5 /
PREPARING YOUR GRAPHICS CARD
STEP 1
REMOVING THE FACTORY PROVIDED BACKPLATE
Remove all encircled screws using a Phillips head screwdriver, then take off
the backplate. Save these screws for later. You will need them when reinstalling
the backplate.
STEP 2
REMOVING THE STOCK COOLER
Remove the remaining screws as shown below. The cooler can now be
gently removed, take care to unplug the LED and Fan connections. If there
are any self-adhesive washers or either side of the PCB these should also
be removed.
STEP 1
STEP 2
