Floorex Products GALAXY 250 G3 E1, Инструкция по безопасности и эксплуатации

Страница: 6 / 29

Page5 GALAXY 250 Generation3
Floorex Products www.floorex.com.au 1800 356 673
Operating Instructions
24. Wear clothes suitable for the job and for the work place including, safety shoes, hard hat, hearing protection,
non-fogging vented safety goggles, and dust respirator suitable for dust.
25. The GALAXY must only be used according to the instructions given in this manual. Any other work methods or
practices could result in injury or death
26. WARNING! Disconnect power before lifting the head off the surface.
27. WARNING! POISONOUS EXHAUST GASES. Do not operate petrol powered equipment, including generators,
without adequate ventilation. Carbon monoxide is and invisible odourless gas that can harm or can kill.
28. Be sure all equipment is tested and tagged prior to use on any job as applicable.
29. Inspect entire area to be ground before grinding and remove any bolts or concrete nails (etc) that could
damage tooling or the machine and which could cause a hazardous situation.
30. Ensure there are no obstacles or existing structures that could present a hazard to the operator. If so, take
necessary action to eliminate the hazard.
31. Tilt machine back so handle is resting along the floor. See Section ‘Tooling Removal’
32. Install appropriate diamond tooling or other available tooling into the machine. Only use genuine Floorex
tooling. Failure to comply could result in bodily injury. See section ‘Tooling Removal’ for illustrations on how to
remove and install tooling.
33. Tilt machine back onto the disk.
34. If the machine is electric version, connect machine to suitable power outlet. Only use heavy duty power lead
suitable for high current use (preferably 2.5mm² cable), no longer than 15 meters.
35. If no power is available within the specified distance, have a qualified person install a suitable power outlet
closer to your work. Alternatively use 4mm² cable for up to 40 meters.
36. Connect a suitable dust extractor to the machine via a 38 or 50mm flexible hose. The machine is designed to
take the standard 50mm hose ends to make connection of dust extractors easy and hassle free. A water
connection for wet grinding is also supplied if this is not practical. In the case of wet grinding, a dust collector
is not needed.
37. Keep machine clear of drainage pits, grates, steps or major lips or such hazard. Failure to comply could result
in bodily injury and or could damage the machine or property.
38. Ensure machine is on a level surface.
39. This machine is designed to operate with the wheels in contact with the floor at all times. Do not operate with
wheels off the floor.