Flo Vigaro, Инструкция по эксплуатации

Страница: 22 / 64

Start-up
22
6 Start-up
6.1 Setting up the FLO Vigaro
The best position for the device is below head level when the patient is lying
down. However, for hygiene reasons the therapy device should not stand on
the floor.
A lower position allows any condensation in the hose to simply flow back into
the air humidifier. Keep the FLO Vigaro out of direct sunlight and away from
heat sources and humid atmospheres.
The FLO Vigaro does not need cleaning before initial use.
Mains connection 100 - 240 V
Take the mains lead supplied and plug it into the device socket. Insert the
other end into a mains socket. The device will detect the mains voltage
automatically.
The FLO Vigaro can now be switched on at the mains.
If the mains switch is always on, electricity is also consumed when the device
is not in use.
To keep power consumption as low as possible the equipment should be
switched off at the mains when not in use.
Operation with 12 V DC or 24 V DC
An additional adapter, which produces the required voltage of 24 V DC, is
needed when operating using 12 V DC.
The corresponding plug is plugged into the equipment's socket for both
voltages.
In this case the equipment does not have to be switched on at the mains, it is
immediately ready for use.
The humidifier lid must be fully inserted in the beaker. Before start-up also
check that the two components have been placed on the heating plate and into
the retaining brackets. If this is not the case, first switch the device off. The
device is switched on after correct installation, and the display then reads
"Standby".
Connect a suitable hose system and mask to the device. Also connect the
pressure gauge hose to the FLO Vigaro.
The FLO Vigaro is now ready for use.