FLIR ThermaCAM P65, Руководство пользователя

Страница: 78 / 246

Action Step
Open the lid of the battery compartment by pressing its locking mechanism. 1
The battery release spring will push out the battery from the battery compartment. 2
Close the lid of the battery compartment. 3
For more information about the battery system, see section 12 – Electrical power
system on page 129.
8.8.7 Removing & attaching the remote control from the camera handle
➲
The remote control is mounted on the camera handle by means of a fixed front
latch and a rear spring-loaded latch. See the figure on page 72.
8.8.7.1 Removing the remote control
10397203;a3
Figure 8.6 Removing the remote control
Action Step
Firmly hold the camera in your left hand and grab the handle of the remote control
in your right hand. 1
Pull the handle backwards until the front of the handle is released from its latch. 2
You can now remove the remote control from the camera handle. 3
8.8.7.2 Attaching the remote control
➲ The remote control should not be attached to the camera handle when you use
the heat shield. The heat shield does not protect the remote control from heat.
8
62
Publ. No. 1557954 Rev. a155 – ENGLISH (EN) – February 7, 2006
8 – Tutorials