FLIR TCX series, Инструкция по эксплуатации

Страница: 57 / 150

Setup 6
6.5.5 Local
NOTE
Local storage is only available when the camera has an installed microSD card.
The Local tab allows you to format or configure the microSD card installed in the camera.
• Click Read Only to set the microSD card on read only mode. This disables microSD
recording.
• Click Read & Write to enable recording on the microSD card.
• Click Hot Swap to unmount the microSD card if you would like to eject it from the
camera.
• Click Format and then click Yes to format the microSD card. The camera will reboot
once the format is completed.
6.5.6 FTP
The FTP tab allows you to set up settings for recording to an FTP server.
To set up FTP settings:
1. Check Enable to enable recording to FTP.
2. Configure the following:
• Server Address: Enter the IP address or DNS address of the FTP server.
• Port: Enter the FTP server port number.
• User Name: Enter the user name for the FTP server.
• Password: Enter the password for the FTP server.
• Remote directory: Enter the recording directory on the FTP server (e.g. share).
NOTE
The recording directory must be located one level below the root directory. For example, share
is acceptable, but not share/recordings.
• Check Emergency (Local) to enable microSD recording if the FTP server cannot
be reached.
3. Click Save to save changes.
6.5.7 NFS
The NFS tab allows you to configure recordings to a NFS (network file system).
#LX400062; r.30885/35920; en-US 49