FLIR QUASAR CP-3211, Руководство пользователя и инструкция по установке, Страница: 76 / 164

September 12, 2016
68
Configuration and Operation
CP-3211/CP-4221 User and Installation Guide
2. Enter the information in the appropriate field. A definition of each of the required fields follows.
·
Country – Enter a two-letter combination code to indicate the specific country in which the
certificate will be used. For instance, type “US” to indicate United States.
· State or province – Enter the local administrative region.
·
Locality – Enter other geographical information.
· Organization – Enter the name of the organization to which the entity identified in
Common Name belongs.
·
Organizational Unit – Enter the name of the organizational unit to which the entity
identified in the Common Name field belongs.
· Common Name – Indicate the name of the person or other entity that the certificate
identifies (often used to identify the website).
3. Click OK to save the details of the certificate request after completion. When the request is
complete, the subject of the Created Request is displayed in the Subject field.
4. To view details of the Certificate Request, click Properties below the Subject field. The
Certificate Request Properties dialog box opens. If you want to remove the certificate, click
Remove .
5. Copy the PEM-formatted request and send it to your CA.
Note:
The self-signed certificate does not provide the same level of security as a CA-issued certificate.
9.3.2.3 IP Filter
The IP filter restricts access to the camera by denying/allowing specific IP addresses. Click the IP filter
tab under the category Security in the sidebar to display the following page.
IP Filter Screen
To enable the IP filter
1. Check the box to enable the IP filter function. Once enabled, the listed IP addresses (IPv4) are
allowed or denied access to the camera.
2. Select Allow or Deny from the drop-down list.
3. Click Apply to determine the IP filter behavior.