Configuration
CB-640x Installation and User Guide Revision 100
February 2021
65
This document does not contain any export-controlled information.
Trap Community String
: Specify the community to use when sending a trap message to the
management system. The default value is
public
. Traps are used by the camera to send messages to
the management system for important events or status changes.
SNMP v3
To enable SNMP v3, move the slider to the right. By default, SNMP v1 is disabled.
User Name
: Specify the user name. The default is
initial
.
Authentication Mode
: Select
MD5
,
SHA
, or
NONE
(default).
Authentication Password
(available when Authentication Mode is set to
MD5
or
SHA
): Specify the
password for authentication.
Privacy Mode
(available when Authentication Mode is set to
MD5
or
SHA
): Select
AES
,
DES
, or
NONE
(default).
Privacy Password
(available when Privacy Mode is set to
AES
or
DES
): Specify the privacy password.
Trap
Mode
: Select
V1
,
V2C
,
V3
, or
OFF
(default), according to the SNMP version that you enabled.
Target IP
: Specify the IP address of the Trap Host.
Heartbeat
: Sends SNMP notifications at regular intervals to detect network delays. To enable it, move
the slider to the right. By default,
Heartbeat
is disabled.
Heartbeat Interval (5-600)
: Specify the interval in seconds for the camera to send heartbeat notifications.
The default is
30
seconds.
Event
: Automatically records the log file of events, for later review. To enable it, move the slider to the
right. By default,
Event
is disabled.
Download MIB
You can download the camera’s MIB (Management Information Base), which describes the structure of
the management data of the camera’s subsystem using a hierarchical namespace containing object
identifiers (OIDs). Each OID identifies a variable that can be read or set via SNMP.
Click
Download
. The database is downloaded.
5.14.3
802.1X
802.1X settings enable the camera to access a network protected by the 802.1X/EAPOL (Extensible
Authentication Protocol over LAN) authentication protocol.
