FLIR E70353, Инструкции по установке и эксплуатации

Страница: 54 / 104

• Note the camera forward markings on the camera base, and make sure the
template is oriented properly relative to the bow of the vessel. This is affected by
whether the camera is to be mounted ball-up or ball-down.
2. Install the 3x threaded studs into the base of the camera with thread-locking
compound. If required, you can use studs of a different length to suit your installation.
3. Slide the seal over the threaded studs, and push it firmly into place on the camera’s
base.
4. Connect the power supply cable and network cable to the camera, and thread
the cables through the central holes.
Note: The right-angled RayNet and power cables supplied are suitable for use with
a mounting surface up to 25.4 mm (1 in) thick. A thicker surface will require the
use of straight-connector cables (available separately).
5. Place the camera on the mounting surface so the threaded studs extend through
the drilled holes.
6. Make the required connections with the free ends of the cables.
7. Slide a flat washer, and then a spring washer, onto each stud.
8. Secure the camera body to the mounting surface with the supplied nuts, ensuring
that the seal remains correctly positioned on the camera’s base.
Tighten the nuts to a torque of 3.7 Nm (2.7 lb-ft).
Dome capped nuts are provided for a neater solution where the mounting is
exposed to view.
Mounting the camera with the optional top-down riser (part
number A80509)
The optional top-down riser (A80509) is used when access to the underside of the
mounting surface is restricted. Use the instructions below to mount the camera unit
using the optional top-down riser (A80509).
1. Using the template provided, mark and drill the holes for mounting the riser.
• Note the camera forward marking on the top surface of the riser. You must
ensure that the riser is mounted so that the camera is oriented properly relative to
the bow of the vessel.
• Only drill the optional cable routing hole in the mounting surface if you intend to
route the cables through the base of the riser, rather than through the side of
the riser.
54