FLIR B6 series, Руководство пользователя

Страница: 157 / 326

22.3.4 Changing Wi-Fi settings
General
If you experience transmission or interference problems, you may need to change
the Wi-Fi settings in the camera.
Procedure Follow this procedure to change Wi-Fi settings:
To go to the mode selector, push the button to the right of the joystick.
1
In the mode selector, select Setup and push the joystick.
2
In the toolbox, select Communications . 3
Select Wi-Fi settings and push the joytick. 4
To select a different channel, use the joystick. Push the joystick to confirm
each choice.
You can use channels 1 to 11. However, since the channels overlap, only
channels 1, 6, and 11 are normally used.
5
In the other device, refresh the list of devices and try to connect to the
camera again 6
To confirm and leave the dialog box, push the button.
7
NOTE
The command Wi-Fi settings will only be available when a WLAN SD-Card, a USB-
WLAN micro adapter, or a USB Wi-Fi micro adapter is inserted into the camera.
Related topics
For locations of camera buttons, see section 9 – Camera parts on page 21.
22
Publ. No. 1558550 Rev. a557 – ENGLISH (EN) – October 7, 2011
139
22 – Changing settings