2
GENERAL SAFETY RULES
WARNING!
READ AND UNDERSTAND ALL INSTRUCTIONS.
Failure to follow all instructions listed below may result in electric shock, fire and/or serious
personal injury.
SAVE THESE INSTRUCTIONS
WORK AREA
DO NOT IMMERSE IN WATER
SUITABLE FOR WET LOCATION USE
Keep your work area clean and well lit.
Cluttered benches
and dark areas invite accidents.
Working temperature.
This worklight is design to be use at
normal room temperature.
FLEXLITE is design to be used in industrial environment
under rain, snow and dust. But FLEXLITE product can not
be immerse in water. If the working area is moist and dusty,
some particles will stick on the fan or heatsink and reduce the
performance. See maintenance section to remove any dirt.
DANGER!
Never connect or disconnect the connector on
the lighthead or any extension cord when the
power is on or in hazardous area.
WARNING!
Use only three-wire outdoor extension cords
that have three-prong grounding plugs and
grounding receptacles that accept the appliance’s plug.
SERVICE
Worklight service must be performed only by qualified
repair personnel.
Service or maintenance performed by
unqualified personnel may result in a risk of injury.
When servicing a worklight, use only identical
replacement parts. Follow instructions in the
Maintenance section of this manual.
Use of unauthorized
parts or failure to follow Maintenance Instructions may
create a risk of shock or injury
.
STORAGE TEMPERATURE
Store worklight at room temperature between 4 and 27°C (40
and 80°F) for best results.
When transporting or temporarily storing in a vehicle,
temperature range should be greater than -30°C (-22°F) but
no more than 66°C (151°F).
Storing worklight at temperatures greater than 76°C
(169°F) for extended periods of time (more than 2 hours)
may
cause
damage
to
worklight.
SPECIFIC SAFETY RULES
Know your worklight. Read User’s manual
carefully. Learn its applications and limitations, as
well as the specific potential hazards related to this
worklight.
Following this rule will reduce the risk of
electric shock, fire, or serious injury.
Lens and housing become hot during use:
During or immediately after use, don’t lay worklight
flat on lens surface or place lens area in contact with
a plastic or fabric covered surface.
Handle worklight with care around any flammable
surface.
Do not use or permit use of worklight in bed or
sleeping bags. This worklight lens can melt fabric
and a burn injury could result.
Do not disassemble your worklight.
Ground
Fault
Circuit
Interrupter
(GFCI)
protection is to be provided on the circuit(s) or
outlet(s) to be used for the wet location portable
luminaire. Receptacles are available having built-in
GFCI protection and are able to be used for this
measure of safety.
Do not permit children to use worklight
unsupervised.
It is not a toy. The temperature of the
light head will become hot after being on for only a
short period of time. This hot temperature can cause
burn injury if touched and can create sufficient heat to
melt some fabrics.
Stay alert.
Watch what you are doing and use common
sense. Do not rush.
If wrapped or in contact with fabrics, the worklight
lens can produce sufficient heat to melt some
fabrics.
To avoid serious personal injury, never allow
the worklight lens to come in contact with anything.
Check damaged parts.
Before further use of this
worklight, a part that is damaged should be carefully
checked to determine that it will operate properly and
perform its intended function. Do not use worklight if
it does not function properly.
