webdyn.com
V2.0 subject to changes | Webdyn © by Flexitron Group
22
2.3 Assembly
2.3.1 Opening/Closing the Box
Follow these steps to open the hub box:
The box can only be opened if it is not fixed to the wall. In the case where the box is fixed to a wall,
it will have to be unhooked to be able to open it.
If the box is wall-mounted:
• Open the 2 doors on the front panel.
•
For the old box, unscrew the 4 wall mounting screws in the recesses under the doors.
•
For the new box, unscrew the 4 screws of the wall mounting in the slots on the front face.
Then follow these steps:
• Unscrew the 4 screws behind the box.
• Remove the cover.
Follow these steps to close the hub box:
• Place the cover on the box base.
• Screw in the 4 screws on the back of the box.
2.3.2 Wall Mounting
The WebdynEasy W M-Bus can be wall-mounted. Before wall-mounting, first close the box (see section
2.3.1: “Opening/closing the box”).
Screws and anchors are not included in the kit. You must choose the correct type of screw for the
type of wall you are fixing the hub to (screw diameter 4mm, head diameter 8mm maximum and length
25mm minimum).
Follow the steps below to fix the hub to a wall:
Old box:
• Open the 2 doors on the front panel.
• Screw the 4 wall mounting screws into the recesses under the doors.
• Close both doors on the front.
