FLENDER RUPER RBS, Руководство по сборке и эксплуатации, Страница: 39 / 78

Operation
7.2 Faults - causes and rectification
M3602-01en Edition 09/2022 39
Fault Cause Rectification
Presence of vibration Incorrect assembly of the coupling.
Check the possible causes given in
sections Assembly-related causes
(Page 39) and Specific installation-re-
lated and maintenance-related causes
(Page 40).
Reassemble the coupling in accord-
ance with these instructions.
Please observe all the stipulations and
requirements given in chapter As-
sembly (Page 25).
Incorrect maintenance of the coupling.
Check the possible causes given in
sections Maintenance-related causes
(Page 40) and Specific installation-re-
lated and maintenance-related causes
(Page 40).
Please observe all the stipulations and
requirements given in chapter Servicing
(Page 43).
Table 7-1: Table of faults
7.2.2.2 Possible causes
7.2 Faults - causes and rectification
7.2.2.2.1 Unsuitable coupling
7.2 Faults - causes and rectification
• Important information on the description of the drive unit and the environment were not
available when the coupling was chosen.
• System torque too high and/or torque dynamics not permissible.
• System speed too high.
• Application factor not selected correctly.
• Chemically aggressive environment not taken into consideration.
• Coupling not suitable for the ambient temperature.
• Diameter and/or assigned fit of the finished bore not permissible.
• Width across corners of the parallel keyways greater than the width across corners of
the parallel keyways in accordance with DIN 6885/1 for the maximum permissible bore.
• Shaft-hub connection incorrectly sized.
• Maximum permissible load conditions not taken into consideration.
• Maximum permissible overload conditions not taken into consideration.
• Dynamic load conditions not taken into consideration.
• Coupling and the machine and/or drive train form a critical torsional, axial or bending vi-
bration system.
7.2.2.2.2 Assembly-related causes
7.2 Faults - causes and rectification
• Damaged parts installed.
• Shaft diameter outside the stipulated tolerance range.
• Coupling parts interchanged and hence not assigned to the specified shaft.
• Stipulated locking elements to prevent axial movements not installed.
• Stipulated tightening torques not adhered to.
• Bolts inserted dry or greased.