FLENDER RUPER RBS, Руководство по сборке и эксплуатации, Страница: 29 / 78

Assembly
5.1 Preparatory work
M3602-01en Edition 09/2022 29
Apply the specified tightening torques as listed in Section Tightening procedure (Page 73).
Finished bore Threaded hole
d
1
Tightening torque
T
A
Nm
Width A/F
Hexagon socket
mm
Over
mm
Up to
mm
8 30 M6 4 3
30 75 M8 8 4
75 95 M12 25 6
95 110 M16 70 8
110 150 M20 130 10
150 230 M24 230 12
230 640 M30 470 14
Table 5-3: Threaded hole, tightening torque and width A/F for RBS type
Apply the specified tightening torques as listed in Section Tightening procedure (Page 73).
Position of the threaded hole with respect to the parallel keyway
The threaded hole for the set screw is positioned on the parallel keyway.
Selection of the set screw
CAUTION
Physical injury
Danger of injury from protruding set screw.
• Please observe the information about selecting the set screw.
Use set screws in accordance with ISO 4029 with a toothed cup point. The size of the set
screw is determined by the bore made. The set screw should fill out the threaded hole as
much as possible and must not protrude beyond the hub.