FLENDER COUPLINGS N-EUPEX 3103en, Руководство по сборке и эксплуатации

Страница: 43 / 64

Type P
Replace the flexible elements (12) without moving the coupled machines.
1. Undo the connection between coupling parts 2 (2) and 3 (3).
2. Move the coupling part 3 (3) axially.
The flexible elements (12) are freely accessible after coupling part 2 (2) has been turned.
3. Remove the flexible elements (12).
4. Install the new flexible elements (12).
Please observe the information in section Use and storage of flexible elements (12)
(Page 59).
When reinstalling the coupling parts please observe the information in chapters Assembly
(Page 21) and Commissioning (Page 33).
Type O
1. In order to replace the flexible elements (12), move the coupled machines apart.
2. Remove the flexible elements (12).
3. Install the new flexible elements (12).
Please observe the information in section Use and storage of flexible elements (12)
(Page 59).
When reinstalling the coupling parts please observe the information in chapters Assembly
(Page 21) and Commissioning (Page 33).
8.4 Removing the coupling
DANGER
Danger from burners and hot coupling parts
Risk of injury due to burners and hot surfaces. Burners or hot coupling parts can lead to an
explosion in potentially explosive atmospheres.
• Wear suitable protective equipment (gloves, safety goggles).
• Ensure that the area is not at risk of explosion.
Procedure
1. Move the coupled machines apart.
2. Secure the coupling parts to prevent them from falling.
3. Remove the axial locking elements (set screw, end plate).
4. Use a suitable pulling fixture.
Servicing
8.4 Removing the coupling
Assembly and operating instructions 3103en
Edition 10/2020
43