background image

 Vanguard® Marker Installation

1

2

1

2

Marker Connections

Flash Head Cable & Ground Connections

Ensure side marker cable connections match all PCB 

labels and included wiring diagram found on the 

inside of the marker box.

IMPORTANT! 

Connections are polarity sensative, 

correct wiring is critical for proper operation.

The flash head cable will tie into the marker box using 

the terminal block located in the lower right corner.  

Ensure the wiring coming from the flash head and 

from the system controller are wired to match polarity 

on the color coded terminal block as seen below.

Use a #8 AWG wire to properly ground the marker box.  

Coat both ends with a corrosion inhibitor.

NOTE!! Ensure wiring is connected according to color 

coded guidelines as seen below.  

(red, red, black, black, ground, ground)

P/N 7904208 Rev 3

NOTE!! If using V3.4 Firmware or above the markers can be 

connected to any of the (4) outputs on the board.

Отзывы: