www.flash-butrym.pl
Page 2
Warning! Verify that the voltage select switch on your unit matches the line
voltage applied. Damage to your fixture may result if the line voltage applied
does not match the voltage indicated on the voltage selector switch. All
fixtures must be connected to circuits with a suitable Earth ground.
1. Preface
1.1 Packing list
Product name
quantity
moving head light
1 pcs
Power -line
1 base
User manual
1 pcs
1.2 Unpacking instructions
On receiving a fixture, carefully unpack the carton, check the contents to ensure
that all parts are presented, and have been received in a good condition. Notify
the shipper immediately and retain packing material for inspection if any parts
appear damaged from shipping or the carton itself shows,sign of mishandling.
Save the carton and all packing materials. In the event that a fixture must be
returned to the factory , it is important that the fixture should be returned in
original factory box and packing.
1.3 AC Power
To determine the power requirements for a particular fixture, see the label affixed
to the back plate of the fixture or referred to the fixtures specification chart. A
fixture listed current rating is its average current draw under normal conditions.
All fixtures must be directly powered off a switched circuit and cannot be run off a
rheostat(variable resist) or dimmer circuit, even if the rheostat or dimmer source
voltage matches the fixtures requirement. Check the fixture or device carefully to
make sure that if a voltage selection switch exits that it is set to the correct line
voltage you will use.
