4. Operating Instructions
4.1. water temperature collector
-Install the battery
Unscrew the thermometer cover counterclockwise, remove the battery insulation
strip or reload the CR2032 coin cell battery. Press the S key on the board to converse
temperature display unit. Press and hold the S button to switch on or off .
- Remote floating sensor registration
Remote floating sensor needs to be registered before use. The registration
operation is as follows: press and hold the C/F button of monitor for three seconds → the
house icon on the upper left of the monitor screen flashes → in remote floating sensor
closed state, press and hold S button three seconds, remote floating sensor sends a
registration request → when the house icon on the monitor display stops flashing and the
serial number is displayed, indicating that the registration is successful. If the registration is
unsuccessful within 10 seconds, the icon disappears, and you need to re-register.
- Place remote floating sensor
Close the cover of the remote floating sensor which is put into the water far away 100
meters from the monitor. To measure the temperature of the bath or pool, tight the rope
through the small hole in the cover so that the remote floating sensor does not drift far
away . When measuring the water temperature of the fish tank, remote floating sensor is
attached to the inner wall of the fish tank by using a plastic suction cup .
1
