TRANSPORT
4 TRANSPORT
4.1 TRANSPORT INSPECTION
Check the fan immediately after you receive it and make sure that
it has not been damaged during transport. If you discover any
damage, get in touch with the transportation company without
delay. Briefly rotate the fan impeller to see that it rotates easily.
Check the information on the fan rating plate.
Proper procedures must be followed when transporting the product!
Faulty conditions in transporting may result in serious damage on
the product
4.2 TRANSPORT SAFETY
The transport material is to be selected according to the packag-
ing and the weight of the product. Loading must be carried out
as instructed.
4.3 INTERMEDIATE STORAGE
If the fan is to be stored before or in between uses, the following
needs to be taken in account:
– Original packaging is to be used. If the storage conditions re-
quire it, additional protection may be added
– The storage environment must be dry, dust-free and not have
a high level of humidity (<70%)
– Storage temperature must be in between –25° C and +40° C
Before commissioning, the respective instructions must be
studied thoroughly.
4.4 LIFTING OF THE FAN
4.4.1 SIZES
≤
071
The fan is to be lifted with three lifting chains/beams (one
attached to the front plate and two to the rear end of the fan).
There are three alternative places to attach the rear lifting hooks,
which are to be used depending on the fan combination.
Wherever possible, use holes on the motor bracket as shown in
the picture below.
In case of a built-on frequency converter, if there is no access to
the hole on the motor bracket behind the frequency converter
assembly bracket, one of the rear chains/beams could be
attached to the hole on the frequency converter assembly bracket
(up to fan size 045).
With bigger fans (or if there are no holes on the motor bracket)
holes on the base frame are to be used. In this case it must be
taken into account not to damage the frequency converter.
Transverse beam must be used if needed.
Beware of damaging the fan while lifting. Always adjust chains/
beams long enough not to get in touch with motor, frequency
converter or impeller.
Centriflow 3D GMPM, GMEB - Installation and Maintenance
4
FläktGroup DC_9853GB_20180425_R0
Specifications are subject to alteration without notice
