I.
III.
II.
IV.
1
2
4
3
6
5
English
18
ENGLISH
GB
I.
II.
Description
Assembly
Assembly instructions
Safety information
• Electrical work and repairs must be
performed by a qualified electrician.
• During installation, always observe
the national installation regulations.
• The luminaire must not be modified
in any way. Risk of electric shock
and accident.
Technical data
1
Luminaire body
2
Wall mount
3
2 x Fastening screws
4
Wrench
5
2 x Screws / plugs
6
Lampshade
1.
Unscrew the fastening screws using
the provided wrench and remove the
wall mount.
2.
Select an installation location without
pipes or cables behind it. Mark the
holes and drill the holes.
3.
Lead the cable through the cable
hole and then fix the wall mount in
place with screws and plugs.
Caution: Make sure the screws
and plugs are suitable for the
wall material.
4.
Connect the cables to the terminal
block (see section III).
5.
Attach the luminaire to the wall
mount by tightening the fastening
screws using the provided wrench.
6.
Insert a suitable light bulb (see
technical data) and attach the
lampshade.
7.
Connect the power supply.
Nominal voltage:
220-240 V~,
50-60 Hz
Rated power:
max. 35 W
Light source:
not included, GU10
max. 35 W
Protection class:
I /
Degree of protection: IP54
Size:
121x80x220 mm
Used symbols
Caution: Risk to health and the
product.
Class I appliance. Must be
connected to a protective
ground.
Caution: Risk of electric shock.
Caution: First disconnect the
power supply for this connection.
Please read these instructions
carefully and keep them safe for
later use!
19
ENGLISH
GB
Connection
III.
Waste disposal
The pictogram with the crossed
out dustbin points to the re-
quirement for separate disposal
of electrical and electronic appliances
(WEEE). Electrical and electronic ap-
pliances can contain hazardous and
environmentally hazardous materials.
Do not dispose of this appliance as
domestic waste. Hand it in at a collec-
tion point for electrical and electronic
waste. By doing so, you will help to
conserve resources and protect the
environment. For further details,
please consult your local authorities.
Lead the cable through the cable hole.
Connect the cables to the terminal
block. Make sure that the connections
are tight and that no loose cable
endings emerge from the terminal.
Tighten the screws and close the cover
of the terminal. The product needs to be
earthed.
L: Brown
: Yellow/Green
N: Blue
Caution: Switch off the luminaire
and wait for the light bulb to cool
down.
Remove the light bulb by turning
anticlockwise and replace it.
Note: Only use light source described in
the technical data.
2. Cleaning
Caution: Let the luminaire cool
down before cleaning.
Wipe the luminaire with a soft, dry cloth
only. Never use scouring powders or
chemical cleaning agents. Never allow
the electrical components to become
damp.
Maintenance and care
IV.
1. Replacing the light source
