Lit. No. 26469
5
September 6, 2001
9828-2
Lift Cylinders with SAE O-Ring Port
1. Turn the jam nut on the fitting as far back as
possible.
2. Lubricate the O-Ring with clean hydraulic oil.
Remove the plug from the cylinder port.
3. Screw fitting into port by hand as far as it will go.
The washer should contact port face and shoulder
of the jam nut threads.
4. Unscrew fitting to proper position, no more than one
full turn.
5. Use one wrench to hold the fitting body in position
and tighten the jam nut with another wrench until
the washer again contacts port face. Tighten 1/8 to
1/4 turn to lock fitting in place.
6. Attach the 18" HP hose to the lift cylinder elbow.
7. Tighten hose on to the fitting until finger tight.
8. Hold the hose from turning and tighten the hose
swivel nut 1/4 turn.
ATTACH LIFT AND ANGLE CYLINDERS
1. Attach the lift cylinder to the headgear with a
1 x 3-5/16" clevis pin and 1/4 x 1-1/2" cotter pin.
Position the hydraulic port so it faces the driver's
side of the snowplow.
NOTE: For 9-1/2' EZ-V
®
Blades, install blade stop kit
26634 before attaching angle cylinders.
2. Attach the angle cylinders to the A-frame with the
two anchor pins and cotter pins. Position the fittings
so they face inward, toward the A-frame.
Anchor Pins
Cotter Pin
Angle Cylinder
Angle Cylinder
Lift
Cylinder
1/4 x 1-1/2" Cotter Pin
1 x 3-5/16" Clevis Pin
Fitting
Jam Nut
Washer
O-Ring
Cylinder
