Fisher & Paykel DH9060P, Инструкция по установке/Руководство пользователя

Страница: 25 / 40

23
Cleaning the condenser filter and evaporator grid
To maintain optimum performance of your dryer the condenser filter and evaporator
grid must be cleaned. The condenser filter and lint filter lights will flash when the
condenser filter requires cleaning, then turn off once you touch
to start your cycle.
z
The condenser filter is located below the door on the left-hand side.
z
The evaporator grid is located behind the condenser filter.
To clean the condenser filter:
1
Switch off the power supply and remove
the power plug.
2
Open the condenser filter cover.
3
Turn the four condenser lock levers 90°
then pull out the condenser filter.
4
Remove rear filter and wipe the surface
clean with your hand.
If you have stacked your dryer using
a Fisher & Paykel stacking kit, slide the
stacking kit tray out prior to opening the
condenser filter cover.
To clean the evaporator grid:
With the condenser filter removed you will be
able to see the evaporator grid. If the surface
of the evaporator grid is dirty, clean it carefully
with a vacuum cleaner using a dusting brush
or a narrow crevice nozzle. Be gentle and do
not bend the fine metal fins.
Cut Hazard. The surface of the evaporator has
sharp edges and contact may result in injury. Handle with care when cleaning the grid
and always keep blades away from fingers and body.
5
Replace the condenser filter.
6
Turn the four condenser filter lock levers to lock the condenser filter back in place again.
Make sure that these locks are engaged securely.
7
Close the condenser filter cover.
CARING FOR YOUR DRYER
Turning the condenser
filter locking levers
Pulling out the
condenser filter